AirNav Systems Forum

AirNav RadarBox and RadarBox24.com => AirNav RadarBox and RadarBox24.com Discussion => Topic started by: JimK on April 19, 2019, 10:56:10 AM

Title: RadarBox Xrange LAT/LON configuration
Post by: JimK on April 19, 2019, 10:56:10 AM
Hello,

Just added an Xrange to my setup along with an original receiver. 2 questions.

1) How do I setup the LAT and LON on the XRange
2) How do I add it to my account.

I have managed to upgrade the Windows version and add its IP address to the Firmware configuration box but I cannot seem to configure location or account information.

Cheers
Title: Re: RadarBox Xrange LAT/LON configuration
Post by: Runway 31 on April 19, 2019, 11:44:28 AM
Hi Jim

1 Log in and on the on the map top left click on  edit and you will see the boxes for Latitude and Longitude.  Fill them in using decimal.  Click exact location then Preview and then save.

2 Contact [email protected] and advise them on your log in details and its PGANRB number

3 Also ask them to upgrade the firmware to enable MLAT

Alan
Title: Re: RadarBox Xrange LAT/LON configuration
Post by: JimK on April 20, 2019, 07:40:10 AM
Runway 31,

Thanks for advice, appears you can't edit the location of the Xrange until its added to your account. Sent a note to support and it got added a few hours later so all fixed now.

Didn't get the upgrade done yet though.
Title: Re: RadarBox Xrange LAT/LON configuration
Post by: Runway 31 on April 20, 2019, 11:32:21 AM
The developer will probably be off over the weekend and it should hopefully get done early next week

Alan